Espar / Eberspacher EasyStart Remote+
The Easystart Remote+ radio remote controller can be used for selecting or pre-setting your Espar / Eberspacher heater operation mode, operation time, also for switching the heater ON / OFF remotely. Can preset your heater to work on required days and time.
- Operation range - approximately 1000 m (direct visual contact).
- Diagnostics function - Heater Fault code reading
- Can be used with Eberspacher / Espar heaters.
Eberspacher /Espar Part Number: 22.1000.34.1700 / 22.1000.34.17.00 / 22 1000 34 1700 / 22 1000 34 17 00 / 221000341700
Voltage: 12v or 24v
Suitable for the following Eberspacher / Espar heaters:
- Airtronic D2 D4 D5 (from 2007 year)
- Hydronic Heaters (from 2009 year)
3 Reviews Hide Reviews Show Reviews
BEST thing I ever added to my heater.
it makes it so easy to start the heater from inside my home, so when I am ready to leave, the truck is TOASTY warm WITHOUT running the engine.
it is a little tricky to wire up, but it just takes a little extra time to figure it out. (the included wiring diagram is NOT clear at all)
Prompt shipping, arrived 2 days after ordering. Remote unit works well and is very convenient for controlling the Hydronic unit on my car.
Very happy with the product. I am able to check the inside temp of my van and start the heater if i wish from inside my home. Having a remote makes wiring the system much easier because the airtronic unit, altitude sensor and easystart remote controller can all be mounted under the passenger seat. The temp sensor and antenna wires are
The only cables that must exit the seat area.
When traveling, the remote fob is right beside the bed in case there is a need for heat during the colder hours of the night